How to Use Launch X431 V Program Key for Dodge RAM

Launch X431 V is verified to add two new keys for Dodge Ram successfully.

I’ve logged in here I got to boot Launch X431 V up. I did a system scan to see what modules it’s equipped. We’re gonna enter into the wireless control module that will go hop in the car hopefully.

Enter special function.

Enter “Program Ignition Keys or Key Fobs”.

Performing this function may change the state of the vehicle, please exercise caution.

This function is to be used when programming a new ignition key or reprogramming an existing. It will program the win functionality along with the RKE functions. Ignition should be in run position while running this function.


Okay, we put in a pin.

Please verify that is the correct PIN for this vehicle before continuing. Warning! Entering the incorrect PIN 3 times will cause the WCM/Win to enter anti-scan lockout.

Place un-programmed ignition key into the ignition, turn the key to the run position and continue.

Authenticating the PIN.

Programming, please wait…

Programming of ignition FOBIK was successfully.
Click Yes. And get window message ” Place un-programmed ignition key into the ignition, turn the key to the run position and continue. ”


Programming of ignition FOBIK was successfully.
Click on “Cancel”.

Communicating, please wait…

I called my friend, and he says not all Chrysler have the PM RFH module, questions me whether or not the vehicle had remote start.
These are the other key fobs the new ones.
We could use this one and see if the remote start works. And it does, so it’s good.
Then we spill it stick it in turn it on, security light on and security light out.



Job is done.

Fowling is the Video:

Be the first to comment

Leave a Reply

Your email address will not be published.


*