VNCI RNM is a versatile diagnostic scanner designed for Nissan, Renault, and Mitsubishi vehicles. This all-in-one device is capable of performing diagnostics, module programming, and immobilizer functions. In this article, we will demonstrate how to program a 2020 Nissan TEANA ABS module using the VNCI RNM device and Nissan Consult III Plus software without a subscription.
Step-by-Step Guide:
1. Install the Nissan Consult III Plus software on your computer.
2. Connect the VNCI RNM device to the vehicle via USB.
3. Run the VNCI Device Manager to ensure the device is properly connected and update the firmware if necessary.
4. Launch the VCI Manager and connect the VCI.
5. Open the Nissan Consult III Plus software.
6. Navigate to Vehicle Selection and choose Altima/Teana L34 2020, then confirm the vehicle information.
7. Select “Other operation,” then “ABS system,” and finally “Program black ECU after ECU Replacement.”
8. Choose manual selection and read the programming instructions carefully. Press Next to continue.
9. Select the appropriate ECU part number and confirm the vehicle information again.
10. Remove the battery terminal caps and connect a battery charger to the battery. Adjust the charger output between 12V and 13.5V.
11. Press Start to begin programming the ABS module.
12. Wait for the programming process to complete.
13. Turn the ignition switch to the OFF position, then back to the ON position. (Diagnostic Trouble Codes) will be automatically erased.
Conclusion:
By following this step-by-step guide, you can successfully program a 2020 Nissan TEANA ABS module using the VNCI RNM device and Nissan Consult III Plus software without a subscription. This powerful combination of hardware and software enables technicians and enthusiasts to perform advanced diagnostics and programming tasks on Nissan, Renault, and Mitsubishi vehicles, saving time and money in the process.
Leave a Reply