One common issue that some customers have encountered when using the Godiag Full Protocol OBD2 Jumper with the OBDSTAR P50 is the failure to read data and the appearance of a communication error. This can be frustrating and may lead to doubts about the functionality of the Godiag Jumper. However, there are a few simple solutions to solve this problem.
Here is the solution.
Just connect CAN H and CAN L cable of Godiag OBD2 jumper via one electrical resistance (120 ohm resistor), then the problem will be solved. The Electrical resistances can be found in the Godiag Breakout Tricore Cable package. There are three in all.
Finally, the customer gave feedback below.
Thanks so much! I tried it and worked fine!
It’s great to hear that the solution worked for the customer, and they were able to successfully reset the airbag on Mazda using OBDSTAR P50 and Godiag OBD2 Jumper.
Leave a Reply