how to bleeding cooling system and check leaks for BMW E39 540i

This instructions show you how to bleeding cooling system and check leaks for BMW E39 540i.These bleeding instructions only apply to vehicles without a latent heat accumulator. For more repair case of BMW,please check BMW Trouble Repair.

Newest BMW Diagnostic Software:

V2022.09 BMW ICOM A2+B+C Diagnostic & Programming Professional TOOL With Engineers Software
Software Version : V2022.09
ISTA – D: 4.36.30 with SDP Programming Database 4.36.32
ISTA – P: 3.70.0.200 with Engineer Programming，supports the programming of BMW motorcycles and electric vehicles can program F/G/I/K chassis for car (through the ICOM, not other cable )
Vin: V2022.07.12
BMW ETK: 2019.12
BMW KSD: 2019.12 Multilanguage
BMW FSC Navigation Code Generator
BMWAiCoder for BMW Coding
Win10 64 bit operating system

Procedures:

To ensure the cooling system is properly vented, it is absolutely essential to follow the steps below:

1.Undo cap but do not remove from expansion tank. This prevent excessive discharge of coolant from the expansion tank.

2.Turn on ignition.

3.Set heating controller to max. temperature.

4.Set blower to low level. This opens the heating valves and sets the auxiliary water pump in operation.

5.Run engine and briefly press accelerator pedal three to four times (approx. 4500 to 5000 rpm) to flush engine cooling circuit.

6.In doing so, do not run engine for longer than approx. 30 seconds; otherwise coolant will heat up and expand.

7.If the coolant level in the expansion tank drops in the process, top up the expansion tank to the max. cold fill level.

8.Screw on cap tightly and allow engine to warm up until thermostat opens.

9.Check coolant level. Pay attention to differing expansion tank designs.

Black expansion tank :

Allow engine to cool down before checking coolant level.

Coolant temperature must not exceed 30° C. If ambient temperature exceeds 30° C,allow engine to cool down at least to ambient temperature.

Check coolant level and if necessary top up coolant to max. cold fill level (the ball on the float needle is on the same level as the top edge of the expansion tank).

Note:

The tank mark indicates the fluid level at approx. 20° C.

Use recommended coolant only.