This guide provides instructions on how to address the CID 0190 FMI 08 engine derate issue in a Perkins 1106D electric power generation (EPG) system.
Preparations:
Perkins EST 2024A & 2023A & 2019A Software Free Download
Perkins SPI2 2018A EPC+Service Manual Free Download
Perkins Communication Adapter 3
Conditions Generating This Code
The Electronic Control Module (ECM) generates this code under the following conditions:
- The ECM detects an intermittent or complete loss of signal from the primary speed/timing sensor for 2 seconds.
- The engine has been running for more than three seconds.
System Response
- If equipped, the diagnostic lamp will flash, and the derate lamp will illuminate. The shutdown lamp may also come on.
- The diagnostic code will be logged.
- The ECM will switch to using the signal from the secondary speed/timing sensor.
Possible Performance Effect
- The engine will be derated.
- If the signal from the secondary speed/timing sensor is also lost, the engine will shut down.
Troubleshooting
This diagnostic code indicates a loss of signal from the primary speed/timing sensor. To address this issue, perform the following diagnostic procedure:
Engine Speed/Timing Sensor Circuit Test
Follow these steps to test the engine speed/timing sensor circuit:
- Check the connections to the primary speed/timing sensor for any signs of damage or corrosion.
- Verify that the wiring to the sensor is intact and properly connected.
- Use a multimeter to check the sensor’s voltage and signal output.
- If any issues are found with the sensor or its wiring, repair or replace the components as necessary.
Results
- OK: If the sensor and its circuit are functioning correctly, the test is complete.
- Not OK: If there are issues with the sensor or its circuit, take corrective action based on the test results.
For more detailed troubleshooting and repair procedures, refer to the Perkins trouble repair manual or contact a certified Perkins technician.
Additional Resources
For more troubleshooting and repair cases related to Perkins engines, please refer to the Perkins Trouble Repair.
Related posts:
- how to solve Perkins 1000 series engine water pump removal difficultly
- Newest Perkins EST 2024A & 2022A & 2019A Full Support Free Download
- Solution for Perkins 1106D Electric Power Generation with CID 0168 and FMI 02
- Troubleshooting Guide for Perkins 1106D Electric Power Generation CID 0172 FMI 03 Error
Leave a Reply