4 Steps to Program VW CC 2014 Key by Xtool X-100 PAD2 Pro

XTOOL X100 PAD 2 full version adds VW 4th & 5th IMMO. This post comes with the guide to use it to add new key to VW CC 2014 by PIN code.

Preparation:

Xtool X-100 PAD2 Pro full Configuration (€813.64 free shipping from UK)

This is comfort control module EEPROM chip of VW CC 2014

Reading EEPROM chip

Prepare two keys: Original one+ blank one

Test two key first

The original key can remote and start the car

The blank key cannot work

Main 4 steps to program key:

Step 1: Get pin code

Step 2: Generate 48 dealer key

Step 3: Match new key

Step 4: Program remote

In detail…

Step 1: Get pin code

Connect X100 PAD2 PRO with KC100 to the vehicle

Insert the original key into ignition

Press X100 PAD2 on the device

Select Immobilization-> VW-> 4th& 5th Immobilizer system、

Turn on ignition switch

Select 4th immobilizer system-> VW Passat/CC (Recommend) -> Get PIN/CS

Follow the prompt to select EEPROM data

Codes will be extracted from EEPROM chip dump file

Step 2: Generate 48 dealer key

Select Generate 48 dealers key to activate KC100 adapter

Then input CS code

Put the blank key to coil

Generate 48 dealer key successfully

Step 3: Match new key

Select Match the key

Enter Pin code and learning key number

Enter the learning mode after confirm immo, use each matched key to turn on ignition switch

Match new key succeed

The original key and new key both can start the car, but the new key cannot remote

Step 4: Program remote

Select Program remote

Turn on ignition switch

Select 46 Central comfort module (CANBUS) -> Erase remote

Erase remote success

Then select Program remote

Press any key of the remote to add once program completed

Finally, the new key is working.