There have some customers who bought Super ICOM PRO N3+ but dont know how to use it , our engineer did some instructions for reference :
1. Plug in the N3+ or connect the test vehicle through the OBD interface, and plug in the N3+ USB cable.
2. Turn on the computer and plug in the computer USB cable.
3. Open the computer network configuration interface and find the “Realtek USB FE Family Controller” network.
4. Click Properties–TCP/IPV4, and set the IP address as shown in the figure below.
5. Click “OK” to complete the wired network configuration.
6. After the setting is completed, the computer is bound to the N3+. After the USB cable is removed, the network icon will disappear, and there is no need to set the IP address when using the N3+ after the computer is wired or wirelessly connected to the Internet. (Note: For the same computer, it is necessary to reset the IP when replacing a new N3+.)
7. Use the BMW special inspection software to test.
8. When using wireless detection, you need to unplug the USB cable on the computer first, and then you will find that the SSID is N3+ICOM-****, connect directly, enter the password 123456789, and you can use the BMW special inspection software directly without equipment.
9. When using the J2534 function of N3+ to test Mercedes-Benz, Toyota, Volkswagen, Honda, Land Rover, etc., first open the special inspection software, install the J2534 driver, select the PassThru menu in the special inspection software, and select the ISO J2534 device in the list.Plug in the USB cable between the computer and N3+, press and hold the N3+ switch button for 3 seconds, the wired and wireless indicator light on the N3+ host will flash, and the test can be performed normally.
10. Use the DOIP function of N3+ to test the DOIP protocol of the new Mercedes-Benz, Volkswagen, Land Rover, etc.:plug in the USB cable between the computer and N3+, press and hold the N3+ switch button for 3 seconds, the wired and wireless indicator light on the N3+ host will flash, then turn on the computer wireless, find N3+ ICOM-**** wireless, connect directly, enter the password 123456789, start the special inspection software, find the DOIP menu and test directly.
11. N3+ is a BMW special inspection tool, 100% runs the BMW special inspection program, and the tested models and inspection results are exactly the same as the BMW special inspection. The multi-function of N3+ is an auxiliary function. Within the test range of J2534 and DOIP, the result is consistent with that of the special inspection, but it does not include all the functions and models of the special inspection. It is mainly for the CAN, K, and DOIP function detection of new OBD models. It can replace J2534 detection cableand ENET cable.
For more interesting for other automotive diagnostic tools , welcome to check our website https://www.obdii.shop
Leave a Reply